Roof And Wall Connection

Finally access can be gained by removing interior.

Roof and wall connection.

There are several ways to gain access to the roof to wall connections in masonry houses. Then the house wrap and exterior wall covering are installed over this roof flashing. For example roof replacement is required for detached single family homes with a value of 300 000 or more that fall in the wind borne debris region that covers nearly half of the state s southern tip. Pocket connection a pocket connection consists of framing the floor or roof system into a void in the masonry wall.

Retrofitting roof to wall connections in masonry houses. In older wood frame construction the connection of roof trusses or rafters to walls is 2 or 3 sixteen penny 16d nails driven at angles toe nailed through the rafter or truss into the top plate of the wall. Another way is to gain access to this connection when the house is being re roofed. One possible way is to gain access through the eave area which may be exposed or through the soffit which is the flat surface at the eaves that forms a sort of ceiling where the roof overhangs the exterior wall.

This detail is used when masonry continues above either as part of the wall or as a parapet the connection location and eccentricity is to be minimized. There sometimes is a problem with movement differences of the wall and the roof decking when the flashing is fastened to both the wall and the roof. Often with new construction the roof flashing is first nailed to the wall.